pulse receiver

См. также в других словарях:

• Pulse-position modulation — is a form of signal modulation in which M message bits are encoded by transmitting asingle pulse in one of 2^M possible time shifts. This is repeated every T seconds, such thatthe transmitted bit rate is M/T bits per second. It is primarily… …   Wikipedia

• Pulse 87 — Type Audio broadcast television network (2008 09) Internet radio station (2010 present) Country …   Wikipedia

• Pulse compression — is a signal processing technique mainly used in radar, sonar and echography to augment the range resolution as well as the signal to noise ratio. This is achieved by modulating the transmitted pulse and then correlating the received signal with… …   Wikipedia

• Pulse-Doppler radar — Pulse Doppler is a radar system capable of not only detecting target location (bearing, range, and altitude), but also measuring its radial velocity (range rate). It uses the Doppler effect to determine the relative velocity of objects; pulses of …   Wikipedia

• Pulse shaping — In digital telecommunication, pulse shaping is the process of changing the waveform of transmitted pulses. Its purpose is to make the transmitted signal suit better to the communication channel by limiting the effective bandwidth of the… …   Wikipedia

• Pulse per second — A Pulse per second (PPS) is an electrical signal that very precisely indicates the start of a second. PPS signals are output by various types of precision clock, including some models of GPS receivers. Depending on the source, properly operating… …   Wikipedia

• pulse radar — A radar in which the transmission consists of short pulses separated by intervals of silence. Such a system employs a single antenna for transmission and reception unlike in continuous wave radar, which has two antennae one for transmission and… …   Aviation dictionary

• Universal asynchronous receiver/transmitter — A universal asynchronous receiver/transmitter (usually abbreviated UART and pronEng|ˈjuːɑrt) is a type of asynchronous receiver/transmitter , a piece of computer hardware that translates data between parallel and serial forms. UARTs are commonly… …   Wikipedia

• Direct-conversion receiver — A direct conversion receiver (DCR), also known as homodyne, synchrodyne, or zero IF receiver, is a radio receiver design that demodulates the incoming radio signal using synchronous detection driven by a local oscillator whose frequency is… …   Wikipedia

• Dielectric wireless receiver — is a type of radiofrequency receiver front end featuring a complete absence of electronic circuitry and metal interconnects. It offers immunity against damage from intense electromagnetic radiation, produced by EMP and HPM sources. This receiver… …   Wikipedia

• Differential pulse-code modulation — (DPCM) is a signal encoder that uses the baseline of pulse code modulation (PCM) but adds some functionalities based on the prediction of the samples of the signal. The input can be an analog signal or a digital signal. If the input is a… …   Wikipedia